ASTM F2591 - 06(2013)

    Standard Specification for Bearing, Roller, Tapered, Single Row of Rollers (Metric Series)

    Active Standard ASTM F2591 | Developed by Subcommittee: F34.04

    Book of Standards Volume: 01.09

      Format Pages Price  
    PDF 5 $50.00   ADD TO CART
    Hardcopy (shipping and handling) 5 $50.00   ADD TO CART

    1. Scope

    1.1 This specification covers requirements for metric series, tapered roller bearings with a single row of rollers.

    1.2 Intended Use—The bearings covered in this specification are intended to be used in general industrial and vehicle applications where the operating temperature does not exceed 120°C (250°F).

    1.3 This specification contains many of the requirements of DS3225, which was originally developed by the Department of Defense and maintained by the Defense Supply Center in Richmond. The following government activity codes may be found in the Department of Defense, Standardization Directory SD-1.2

    Preparing Activity


    Review Activities






    Navy –MC, SH


    Air Force-99

    Air Force-84




    1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

    1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ABMA Standard

    ABMA 19.1 Tapered Roller Bearings--Radial, Metric Design

    ISO Standard

    ISO 5593 Rolling Bearings--Vocabulary

    Military Standard

    MIL-C-11796 Corrosion Preventative Compound, Petrolatum, Hot Application

    SAE Standard

    SAE AMS-STD-66 Steel: Chemical Composition and Hardenability

    ICS Code

    ICS Number Code 21.100.20 (Rolling bearings)

    UNSPSC Code

    UNSPSC Code 31171505(Roller bearings)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F2591-06R13

    Citation Format

    ASTM F2591-06(2013), Standard Specification for Bearing, Roller, Tapered, Single Row of Rollers (Metric Series), ASTM International, West Conshohocken, PA, 2013,

    Back to Top