If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM F2447 - 05(2018)

    Standard Practice for Production Acceptance Test Procedures for Weight-Shift-Control Aircraft

    Active Standard ASTM F2447 | Developed by Subcommittee: F37.40

    Book of Standards Volume: 15.09

      Format Pages Price  
    PDF 2 $46.00   ADD TO CART
    Hardcopy (shipping and handling) 2 $46.00   ADD TO CART

    Significance and Use

    2.1 The purpose of this practice is to establish that each production aircraft has been assembled properly and operates normally throughout its entire allowable flight envelope.

    2.2 If final assembly is completed outside of the main production facility, the manufacturer shall specify the required procedures and what persons are authorized to perform them.

    1. Scope

    1.1 The following requirements apply for the manufacture of weight-shift-control aircraft. This practice includes the production acceptance test requirements for weight-shift-control aircraft.

    1.2 This practice applies to aircraft seeking civil aviation authority approval, in the form of flight certificates, flight permits, or other like documentation.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory requirements prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    ICS Code

    ICS Number Code 49.020 (Aircraft and space vehicles in general)

    UNSPSC Code

    UNSPSC Code 25132005(Ultra light aircraft)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F2447-05R18

    Citation Format

    ASTM F2447-05(2018), Standard Practice for Production Acceptance Test Procedures for Weight-Shift-Control Aircraft, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top