If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM F2246 - 06(2013)

    Standard Specification for Bearing, Roller, Needle: Thick Outer Ring With Rollers and Cage

    Active Standard ASTM F2246 | Developed by Subcommittee: F34.04

    Book of Standards Volume: 01.09

      Format Pages Price  
    PDF 4 $48.00   ADD TO CART
    Hardcopy (shipping and handling) 4 $48.00   ADD TO CART

    1. Scope

    1.1 This specification covers needle roller bearings having thick outer rings, with rollers and cages.

    1.2 The bearings being specified are intended to be used with hardened shafts (HRC58-65; see Test Methods E18). For use with unhardened shafts, bearings should be used in conjunction with inner bearing ring MS51962 as specified in Specification F2431 and shown as MS500072 bearing assemblies in Specification F2430.

    1.3 The use of recycled materials that meet the requirements of the applicable material specification without jeopardizing the intended use of the item is encouraged.

    1.4 Bearings designed to this specification are intended for use in applications requiring high radial load with minimal angular shaft misalignment.

    1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    Note 1This specification contains many of the requirements of MS51961 which was originally developed by the Department of Defense and maintained by the Defense Supply Center Richmond.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    E18 Test Methods for Rockwell Hardness of Metallic Materials

    F2430 Specification for Bearing, Roller, Needle: Assembly (Thick Outer Race)

    F2431 Specification for Ring Bearing, Inner: For Needle Roller Bearing with Thick Outer Ring

    ANSI Standard

    ANSI B46.1 Surface Texture (Surface Roughness, Waviness, and Lay)

    SAE Standards

    SAE AMS-STD-66 Steel: Chemical Composition and Hardenability

    SAE J-404 Chemical Compositions of SAE Alloy Steels

    Military Standards

    MIL-STD-130 Identification Marking of U.S. Military Property

    MS500072 Bearing, Roller, Needle: Assembly (Thick Outer Race)

    MS51962 Ring Bearing, Inner: For Needle Roller Bearing with Thick Outer Ring

    American Bearing Manufacturers Association Standard

    ABMA 18.1 Needle Roller Bearings Radial, Inch Design

    International Organization for Standardization Standards

    ISO 3096 Rolling Bearings--Needle Rollers--Dimensions and Tolerances

    ISO 492 Rolling Bearings--Radial Bearings--Tolerances

    ISO 5593 Rolling Bearings--Vocabulary

    ICS Code

    ICS Number Code 21.100.20 (Rolling bearings)

    UNSPSC Code

    UNSPSC Code 31171505(Roller bearings); 31171512(Needle bearings)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F2246-06R13

    Citation Format

    ASTM F2246-06(2013), Standard Specification for Bearing, Roller, Needle: Thick Outer Ring With Rollers and Cage, ASTM International, West Conshohocken, PA, 2013, www.astm.org

    Back to Top