| Format | Pages | Price |   |
![]() |
15 | $58.00 | ![]() |
|
![]() |
Hardcopy (shipping and handling) | 15 | $58.00 | ![]() |
![]() |
Standard + Redline PDF Bundle ![]() |
30 | $69.00 | ![]() |
Historical Version(s) - view previous versions of standard
More F15.21 Standards Related Products Standard References
1. Scope
1.1 This consumer safety specification covers establishment of requirements, test methods, and marking requirements to promote safe use of an infant bouncer seat by an occupant and a caregiver.
1.2 For purposes of this consumer safety specification, an infant bouncer seat is a freestanding product intended to support an occupant in a reclined position to facilitate bouncing by the occupant, with the aid of a caregiver or by other means. Intended occupants are infants who have not developed the ability to sit up unassisted (approximately 0 to 6 months of age).
1.3 This consumer safety specification is intended to minimize the risk of injury to an occupant resulting from normal use and reasonably foreseeable misuse or abuse of an infant bouncer seat.
1.4 No infant bouncer seat produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein.
1.5 This consumer safety specification is not intended to address incidents and injuries resulting from the interaction of other persons with the occupant in an infant bouncer seat or the incidents resulting from abuse or misuse by other children.
1.6 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.7 The following precautionary caveat pertains only to the test method portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory requirements prior to use.
1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Federal Regulations
16 CFR 1500.48 Technical Requirements for Determining a Sharp Point in Toys or Other Articles Intended for Use by Children Under Eight Years of Age 16 CFR 1500.49 16 CFR 1501 Method for Identifying Toys and Other Articles Intended for Use by Children Under Three Years of Age Which Present Choking, Aspiration or Ingestion Hazards Because of Small PartsOther References
CAMI Infant Dummy, Mark II (see ) Department of Transportation, Federal Aviation Administration, Drawing No. SA-1001. CAMI Newborn Dummy (see )ASTM Standards
D3359 Test Methods for Rating Adhesion by Tape Test
F404 Consumer Safety Specification for High Chairs
F963 Consumer Safety Specification for Toy Safety
F2050 Consumer Safety Specification for Hand-Held Infant Carriers
ANSI Standards
ANSI Z535.4 ANSI Z535.6 Product Safety Information in Product Manuals, Instructions, and Other Collateral MaterialsICS Code
ICS Number Code 97.190 (Equipment for children)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/F2167-19
Citation Format
ASTM F2167-19, Standard Consumer Safety Specification for Infant Bouncer Seats, ASTM International, West Conshohocken, PA, 2019, www.astm.org
Back to Top