ASTM F2030 - 11(2020)

    Standard Specification for Paintball Cylinder Burst Disk Assemblies

    Active Standard ASTM F2030 | Developed by Subcommittee: F08.24

    Book of Standards Volume: 15.07

      Format Pages Price  
    PDF 3 $44.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $44.00   ADD TO CART


    This specification covers cylinder burst disk assemblies for paintball marker propellant sources their application and installation requirements. The materials and processes used to manufacture the burst disk assembly shall result in items with mechanical strength sufficient to pass the applicable burst pressure tests. Materials used shall be corrosion resistant, chemically compatible with the propellant used, and shall not promote galvanic action. The burst disk assembly and related port features shall be free of burrs and sharp edges. Burst disk assemblies intended for use with the specified service pressure shall meet the prescribed rupture pressure and temperature conditions. The relief hole in the burst disk assembly shall provide for flow to adequately vent the cylinder as specified. The rupture disk and seal shall be permanently retained on the plug to provide proper alignment and assembly. The burst disk assembly and port shall conform to the physical envelope as described in the illustrations given. The burst disk shall be marked with manufacturer code and rated burst pressure. Prior to installation the mating port and the burst disk assembly shall be inspected to confirm compliance with physical envelope requirements, cleanliness, and general suitability for use.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers burst disk assemblies for paintball marker propellant sources their application and installation requirements.

    1.2 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    Code of Federal Regulations

    ICS Code

    ICS Number Code 97.220.40 (Outdoor and water sports equipment)

    UNSPSC Code

    UNSPSC Code 49220000(Sports equipment and accessories)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F2030-11R20

    Citation Format

    ASTM F2030-11(2020), Standard Specification for Paintball Cylinder Burst Disk Assemblies, ASTM International, West Conshohocken, PA, 2020,

    Back to Top