| Format | Pages | Price |   |
![]() |
17 | $58.00 | ![]() |
|
![]() |
Hardcopy (shipping and handling) | 17 | $58.00 | ![]() |
![]() |
Standard + Redline PDF Bundle ![]() |
34 | $69.00 | ![]() |
Historical Version(s) - view previous versions of standard
More F15.20 Standards Related Products Standard References
1. Scope
1.1 This consumer safety specification establishes performance requirements, test methods, and labeling requirements to promote the safe use of infant bath seats. Products commonly referred to as bath rings also are included in the scope of this specification. Traditional infant bath tubs that are used to bathe an infant are not within the scope of this standard.
1.2 This consumer safety specification is intended to reduce the risk of death and minimize injury to infants resulting from use and reasonably foreseeable abuse of infant bath seats.
1.3 No infant bath seat produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein.
1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.5 The following precautionary caveat pertains only to the test methods portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D3359 Test Methods for Rating Adhesion by Tape Test
F404 Consumer Safety Specification for High Chairs
F963 Consumer Safety Specification for Toy Safety
F977 Consumer Safety Specification for Infant Walkers
ICS Code
ICS Number Code 97.190 (Equipment for children)
UNSPSC Code
UNSPSC Code 56101813(Bath seats)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/F1967-19
Citation Format
ASTM F1967-19, Standard Consumer Safety Specification for Infant Bath Seats, ASTM International, West Conshohocken, PA, 2019, www.astm.org
Back to Top