ASTM F18 - 12(2017)

    Standard Specification and Test Method for Evaluation of Glass-to-Metal Headers Used in Electron Devices

    Active Standard ASTM F18 | Developed by Subcommittee: F01.03

    Book of Standards Volume: 10.04


      Format Pages Price  
    PDF 5 $46.00   ADD TO CART
    Hardcopy (shipping and handling) 5 $46.00   ADD TO CART


    1. Scope

    1.1 This specification and test method cover acceptance requirements for headers used in electron devices and describes procedures for determining conformance to these requirements.

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.3 The following safety hazard caveat pertains only to the test method (Sections 7 – 13) described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    ICS Code

    ICS Number Code 31.240 (Mechanical structures for electronic equipment)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F0018-12R17

    Citation Format

    ASTM F18-12(2017), Standard Specification and Test Method for Evaluation of Glass-to-Metal Headers Used in Electron Devices, ASTM International, West Conshohocken, PA, 2017, www.astm.org

    Back to Top