You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    ASTM F1769-97

    Standard Test Method for Measurement of Diffusivity, Solubility, and Permeability of Organic Vapor Barriers Using a Flame Ionization Detector (Withdrawn 2004)

    Withdrawn Standard: ASTM F1769-97 | Developed by Subcommittee: F02.30


      Format Pages Price  
    PDF 7 $60.00   ADD TO CART


    Withdrawn Rationale:

    This test method covers the measurement of volatile organic-vapor-barrier properties of films, plastic sheeting, coated papers, and laminates. The specific material properties measured include diffusivity, solubility, and permeability coefficients; parameter values which are required for the solution of mass transfer problems associated with nonsteady state and steady state conditions.

    Formerly under the jusrisdiction of Committee F02 on Flexible Barrier Materials, this test method was withdrawn in June 2004.

    1. Scope

    1.1 This test method covers the measurement of volatile organic-vapor-barrier properties of films, plastic sheeting, coated papers, and laminates. The specific material properties measured include diffusivity, solubility, and permeability coefficients; parameter values which are required for the solution of mass transfer problems associated with nonsteady state and steady state conditions.

    1.2 Applicable test vapors include volatile organic compounds which are detectable by a flame ionization detector. Examples of applicable permeation compounds include solvents, organic film additives, flavor compounds, and aroma compounds.

    1.3 This test method assumes the material being measured exhibits Fickian behavior and uses the solutions to Fick's Laws for a planar surface as the data regression model. (See Annex A1.)

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F1769-97

    Citation Format

    ASTM F1769-97, Standard Test Method for Measurement of Diffusivity, Solubility, and Permeability of Organic Vapor Barriers Using a Flame Ionization Detector (Withdrawn 2004), ASTM International, West Conshohocken, PA, 1997, www.astm.org

    Back to Top