ASTM F1685 - 00(2019)

    Standard Specification for Pressure-Reducing Manifolds for Air or Nitrogen Systems

    Active Standard ASTM F1685 | Developed by Subcommittee: F25.11

    Book of Standards Volume: 01.08


      Format Pages Price  
    PDF 11 $54.00   ADD TO CART
    Hardcopy (shipping and handling) 11 $54.00   ADD TO CART



    Abstract

    This specification covers the design, construction, testing and operating requirements for pressure-reducing manifolds for air or nitrogen systems, which constitute the combination of all components and piping between, and including, the inlet and outlet ports. The manufactured manifolds shall perform satisfactorily to the following procedures: visual examination; hydrostatic shell test; relief-valve lift test; seat tightness test; and external leakage test.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers the design, construction, testing and operating requirements for pressure-reducing manifolds for air or nitrogen systems, referred to herein also as manifolds. The term manifold constitutes the combination of all components and piping between, and including, the inlet and outlet ports (see Fig. 1 and Fig. 2).

    FIG. 1 Manifold Configuration

     Manifold Configuration  Manifold Configuration

    FIG. 2 Manifold Configuration

    Manifold ConfigurationManifold Configuration

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    F992 Specification for Valve Label Plates

    F1508 Specification for Angle Style, Pressure Relief Valves for Steam, Gas, and Liquid Services

    F1795 Specification for Pressure-Reducing Valves for Air or Nitrogen Systems


    ICS Code

    ICS Number Code 23.060.40 (Pressure regulators)

    UNSPSC Code

    UNSPSC Code 27131601(Air manifolds)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F1685-00R19

    Citation Format

    ASTM F1685-00(2019), Standard Specification for Pressure-Reducing Manifolds for Air or Nitrogen Systems, ASTM International, West Conshohocken, PA, 2019, www.astm.org

    Back to Top