If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM F1523 - 94(2018)

    Standard Guide for Selection of Booms in Accordance With Water Body Classifications

    Active Standard ASTM F1523 | Developed by Subcommittee: F20.11

    Book of Standards Volume: 11.08

      Format Pages Price  
    PDF 2 $48.00   ADD TO CART
    Hardcopy (shipping and handling) 2 $48.00   ADD TO CART

    Significance and Use

    4.1 This guide is to be used to assist in the selection of containment boom in accordance with water body classifications.

    4.2 A small number of key parameters that generally affect boom performance have been used in Table 1, in order to enable the user to readily identify general criteria for boom selection.

    4.3 Many factors, other than those listed in Table 1, may be important in selecting containment boom for a particular application. Such factors include: flotation element length, wave length, the effect of stronger than minimum required strength members, shock loads, abrasion resistance, stability in roll, resistance to bridging, interval between anchor points and hand holds, use of reflectors or lighting, compatibility with fresh or salt water, and resistance to sunlight exposure.

    4.4 The values given in Table 1 are the recommended minimums for general purpose booms. As identified in 2.3, operational considerations may require trade-offs in boom properties. Special purpose booms, and general purpose booms used in special circumstances, may perform effectively with boom property values above or below those recommended in Table 1.

    4.5 Effective operation of oil spill control equipment depends on many factors, of which the prevailing environmental conditions are just a few. Factors such as, but not limited to, deployment techniques, level of training, personnel performance, and mechanical reliability can also affect equipment performance.

    1. Scope

    1.1 This guide covers the selection of containment boom that may be used to control spills of oil and other substances that float on a body of water.

    1.2 This guide does not address the compatibility of spill control equipment with spill products. It is the user's responsibility to ensure than any equipment selected is compatible with anticipated products.

    1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D751 Test Methods for Coated Fabrics

    F625 Practice for Classifying Water Bodies for Spill Control Systems

    F715 Test Methods for Coated Fabrics Used for Oil Spill Control and Storage

    F1093 Test Methods for Tensile Strength Characteristics of Oil Spill Response Boom

    ICS Code

    ICS Number Code 47.020.40 (Lifting and cargo handling systems)

    UNSPSC Code

    UNSPSC Code 77131502(Oil spillage control services); 77101501(Risk or hazard assessment)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F1523-94R18

    Citation Format

    ASTM F1523-94(2018), Standard Guide for Selection of Booms in Accordance With Water Body Classifications, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top