You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    ASTM F151-86(1997)

    Standard Test Method for Residual Solvents in Flexible Barrier Materials (Withdrawn 2004)

    Withdrawn Standard: ASTM F151-86(1997) | Developed by Subcommittee: F02.30


      Format Pages Price  
    PDF 5 $60.00   ADD TO CART


    Withdrawn Rationale:

    This test method provides an index for comparing the level of solvents retained in flexible barrier materials of the same construction which result from casting, coating, printing, or laminating operations.

    Formerly under the jurisdiction of Committee F02 on Flexible Barrier Materials, this test method was withdrawn in June 2004.

    1. Scope

    1.1 This test method provides an index for comparing the level of solvents retained in flexible barrier materials of the same construction which result from casting, coating, printing, or laminating operations.

    1.2 This test method does not yield absolute quantitative measurements of solvents retained in flexible barrier materials.

    1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 8 and Note 6.



    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F0151-86R97

    Citation Format

    ASTM F151-86(1997), Standard Test Method for Residual Solvents in Flexible Barrier Materials (Withdrawn 2004), ASTM International, West Conshohocken, PA, 1997, www.astm.org

    Back to Top