You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    ASTM F1425-06(2011)

    Standard Test Method for Determining the Tribocharge of Two-Component Developer Materials (Withdrawn 2020)

    Withdrawn Standard: ASTM F1425-06(2011) | Developed by Subcommittee: F05.04


      Format Pages Price  
    PDF 4 $52.00   ADD TO CART


    Withdrawn Rationale:

    This test method describes a technique for measuring the tribocharge or charge-to-mass ratio of a sample of developer material.

    Formerly under the jurisdiction of Committee F05 on Business Imaging Products, this test method was withdrawn in January 2020 in accordance with section 10.6.3 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

    1. Scope

    1.1 This test method describes a technique for measuring the tribocharge or charge-to-mass ratio of a sample of developer material.

    1.2 This test method determines the concentration of toner in a sample of developer material.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    F335 Terminology Relating to Electrostatic Imaging


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F1425-06R11

    Citation Format

    ASTM F1425-06(2011), Standard Test Method for Determining the Tribocharge of Two-Component Developer Materials (Withdrawn 2020), ASTM International, West Conshohocken, PA, 2011, www.astm.org

    Back to Top