If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM F1385 - 07(2018)

    Standard Practice for Platforms in Cargo Tanks

    Active Standard ASTM F1385 | Developed by Subcommittee: F25.03

    Book of Standards Volume: 01.07

      Format Pages Price  
    PDF 5 $52.00   ADD TO CART
    Hardcopy (shipping and handling) 5 $52.00   ADD TO CART

    Significance and Use

    3.1 This practice establishes the procedure for the construction and installation of platforms to be fabricated and installed by the shipyards within the cargo tanks.

    1. Scope

    1.1 This practice provides design, construction, and installation criteria for platforms in cargo tanks.

    1.2 Where platforms are attached to ladders see Figs. 1-4.

    FIG. 1 Cargo Platform—Bulkhead

     Cargo Platform—Bulkhead Cargo Platform—Bulkhead

    FIG. 2 Cargo Platform Elevation

     Cargo Platform Elevation Cargo Platform Elevation

    FIG. 3 Cargo Platform—Girder

     Cargo Platform—Girder Cargo Platform—Girder

    FIG. 4 Cargo Platforms Showing Typical Sections

     Cargo Platforms Showing Typical Sections Cargo Platforms Showing Typical Sections

    1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are included for information only and are not considered standard

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    Federal Standard

    FED-SPEC-RR-C-271 Chain and Attachments, Welded and Weldless

    Other Standards

    SAE-AMS-C-27725 Coatings, Corrosion Preventative, Polyurethane, for Aircraft Integral Fuel Tanks for Use to 250 Degrees F (121 Degrees C)

    AWS Standard

    AWS D1.1 Structural Welding CodeSteel

    ABS Standard

    American Bureau of Shipping Rules for Building and

    ASTM Standards

    A36/A36M Specification for Carbon Structural Steel

    ICS Code

    ICS Number Code 47.020.10 (Hulls and their structure elements)

    UNSPSC Code

    UNSPSC Code 25111900(Marine craft systems and subassemblies)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F1385-07R18

    Citation Format

    ASTM F1385-07(2018), Standard Practice for Platforms in Cargo Tanks, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top