If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM F1330 - 91(2018)

    Standard Guide for Metallic Abrasive Blasting to Descale the Interior of Pipe

    Active Standard ASTM F1330 | Developed by Subcommittee: F25.11

    Book of Standards Volume: 01.07

      Format Pages Price  
    PDF 3 $46.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $46.00   ADD TO CART

    Significance and Use

    3.1 The maximum length and minimum diameter of the pipe shall be determined by the capacity of the blast equipment used.

    3.2 This guide is recommended for removing mill scale, rust scale, paints, zincs, and oxides.

    1. Scope

    1.1 This guide covers metallic abrasive blasting to descale the interior of carbon steel pipe.

    1.2 This guide is recommended for use in conjunction with an abrasive reclamation system.

    1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    Other Documents

    SFSA 20-66 Standard Specification for Cast Steel Abrasives Available from Steel Founders Society of America (SFSA), 780 McArdle Dr., Unit G, Crystal Lake, IL 60014, http://www.sfsa.org.

    SSPC SP10

    SAE Standards

    J444 Cast Shot and Grit Size Specifications for Peening Cleaning

    J827 Cast Steel Shot

    ASTM Standards

    D2200 Practice for Use of Pictorial Surface Preparation Standards and Guides for Painting Steel Surfaces

    E18 Test Methods for Rockwell Hardness of Metallic Materials

    ICS Code

    ICS Number Code 23.040.01 (Pipeline components in general. Pipelines)

    UNSPSC Code

    UNSPSC Code 11101704(Steel)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F1330-91R18

    Citation Format

    ASTM F1330-91(2018), Standard Guide for Metallic Abrasive Blasting to Descale the Interior of Pipe, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top