You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM F1179-88(2014)

    Standard Practice for Inspection Procedure for Use of Anaerobic Thread Locking Compounds with Studs (Withdrawn 2020)

    Withdrawn Standard: ASTM F1179-88(2014) | Developed by Subcommittee: F25.07


      Format Pages Price  
    PDF 2 $56.00   ADD TO CART


    Withdrawn Rationale:

    This practice covers an inspection procedure to ensure that studs installed with an anaerobic thread locking compound have achieved the necessary backout resistance.

    Formerly under the jurisdiction of Committee F25 on Ships and Marine Technology, this practice was withdrawn in December 2020. This standard is being withdrawn without replacement due to its limited use by industry.

    1. Scope

    1.1 This practice covers an inspection procedure to ensure that studs installed with an anaerobic thread locking compound have achieved the necessary backout resistance.

    1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F1179-88R14

    Citation Format

    ASTM F1179-88(2014), Standard Practice for Inspection Procedure for Use of Anaerobic Thread Locking Compounds with Studs (Withdrawn 2020), ASTM International, West Conshohocken, PA, 2014, www.astm.org

    Back to Top