ASTM F1172 - 88(2019)

    Standard Specification for Fuel Oil Meters of the Volumetric Positive Displacement Type

    Active Standard ASTM F1172 | Developed by Subcommittee: F25.11

    Book of Standards Volume: 01.07


      Format Pages Price  
    PDF 4 $46.00   ADD TO CART
    Hardcopy (shipping and handling) 4 $46.00   ADD TO CART



    Abstract

    This specification provides the minimum requirements for the design, fabrication, pressure rating, marking, and testing for fuel oil meters (volumetric positive displacement type). The components of the meter shall be the following: housing, measuring chamber, adjusting device, direction marker, and register. Meter properties such as capacity, pressure drop, normal flow error, and maintainability shall be determined. Meters shall have all burrs or sharp edges removed and shall be cleaned of all loose metal chips and other foreign substances. A representative fuel oil meter shall undergo calibration and adjustment and hydrostatic test.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification provides the minimum requirements for the design, fabrication, pressure rating, marking, and testing for fuel oil meters (volumetric positive displacement type).

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.3 The following safety hazards caveat pertains only to the test method section of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    F722 Specification for Welded Joints for Shipboard Piping Systems


    ICS Code

    ICS Number Code 75.200 (Petroleum products and natural gas handling equipment)

    UNSPSC Code

    UNSPSC Code 40170000(Pipe piping and pipe fittings)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F1172-88R19

    Citation Format

    ASTM F1172-88(2019), Standard Specification for Fuel Oil Meters of the Volumetric Positive Displacement Type, ASTM International, West Conshohocken, PA, 2019, www.astm.org

    Back to Top