If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM F1074 - 87(2018)

    Standard Specification for Cleats, Welded Horn Type

    Active Standard ASTM F1074 | Developed by Subcommittee: F25.03

    Book of Standards Volume: 01.07

      Format Pages Price  
    PDF 3 $48.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $48.00   ADD TO CART


    This specification covers hollow welded horn type cleats and pads for marine use. The cleats shall be used where securing of boat handling lines are required onboard commercial and navy boats and crafts. The horn cleats shall be of galvanized steel, grade 1023W; the base plate shall be of the prescribed steel composition; and all chafing surfaces shall have the specified finish. The cleats’ horns shall be of cast steel, round in shape, and free of burrs or sharp edges. The requirements for welding of horns to a base plate are illustrated. The dimensional requirements for cleat, rope circumference, and roper diameter are specified. Requirements for packaging and product marking are given as well.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers hollow cleats and pads for marine use.

    1.2 The cleats shall be used where securing of boat handling lines are required onboard commercial and navy boats and crafts.

    1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A36/A36M Specification for Carbon Structural Steel

    A370 Test Methods and Definitions for Mechanical Testing of Steel Products

    A385 Practice for Providing High-Quality Zinc Coatings (Hot-Dip)

    ICS Code

    ICS Number Code 47.020.50 (Deck and other equipment and installations)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F1074-87R18

    Citation Format

    ASTM F1074-87(2018), Standard Specification for Cleats, Welded Horn Type, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top