If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM F1063 - 09(2018)

    Standard Practice for Functional Inspections and Adjustments of Alpine Ski/Binding/Boot Systems

    Active Standard ASTM F1063 | Developed by Subcommittee: F27.50

    Book of Standards Volume: 15.07

      Format Pages Price  
    PDF 9 $54.00   ADD TO CART
    Hardcopy (shipping and handling) 9 $54.00   ADD TO CART

    Significance and Use

    4.1 The purpose of this practice is to aid in providing the end user with an appropriately functioning system with appropriate release torque setting(s).

    4.2 The definitions and tolerances defined in this practice do not necessarily apply to procedures incorporating an inspection interval or schedule, in which such procedures are specified by the binding manufacturer. This practice is not intended to be a method for evaluating equipment design.

    Note 2: Refer to Practice F1064 for definitions and tolerances pertaining to the evaluation of equipment once in use.

    1. Scope

    1.1 This practice provides procedures for inspection and adjustment of alpine ski/binding/boot systems.

    1.2 This practice should be followed for systems, whether newly mounted or previously mounted, when work is performed on the system that may affect its release function, unless otherwise specified by the binding manufacturer in non-rental applications.

    1.3 Nonapplicability of this function and release inspection practice to rental shop operations is based upon the existence of applicable ASTM practices.

    Note 1: Refer to Practice F1064 for equivalent procedures and tolerances for complete and incomplete rental systems.

    1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

    1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    F939 Practice for Selection of Release Torque Values for Alpine Ski Bindings

    F1061 Specification for Ski Binding Test Devices

    F1064 Practice for Sampling and Inspection of Complete and Incomplete Alpine Ski/Binding/Boot Systems in Rental Applications

    ICS Code

    ICS Number Code 97.220.20 (Winter sports equipment)

    UNSPSC Code

    UNSPSC Code 49151500(Skiing and snowboarding equipment)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/F1063-09R18

    Citation Format

    ASTM F1063-09(2018), Standard Practice for Functional Inspections and Adjustments of Alpine Ski/Binding/Boot Systems, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top