If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM E873 - 82(2019)

    Standard Test Method for Bulk Density of Densified Particulate Biomass Fuels

    Active Standard ASTM E873 | Developed by Subcommittee: E48.05

    Book of Standards Volume: 05.06

      Format Pages Price  
    PDF 2 $48.00   ADD TO CART
    Hardcopy (shipping and handling) 2 $48.00   ADD TO CART

    Significance and Use

    2.1 The test procedures described in this test method can be used to determine the bulk density (or bulk specific weight) of any densified particulate biomass fuel meeting the requirements specified in this test method.

    1. Scope

    1.1 This test method covers the procedure for the determination of bulk density (or bulk specific weight) of densified particulate biomass fuels with a maximum particle volume of 16.39 cm3 (1 in. 3).

    1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    ICS Code

    ICS Number Code 75.160.10 (Solid fuels)

    UNSPSC Code

    UNSPSC Code 15101800(Plant based liquid fuels or biofuels)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/E0873-82R19

    Citation Format

    ASTM E873-82(2019), Standard Test Method for Bulk Density of Densified Particulate Biomass Fuels, ASTM International, West Conshohocken, PA, 2019, www.astm.org

    Back to Top