| ||Format||Pages||Price|| |
|2||$50.00||  ADD TO CART|
This test method covers determination of the ash content in the analysis sample of refuse-derived fuel (RDF). The results obtained can be applied as the weight percent ash in the proximate analysis and in the ultimate analysis.
Formerly under the jurisdiction of ASTM Committee D34 on Waste Management, this standard was withdrawn with no replacement in July 2011 because of limited use by industry in light of analogous standards for coal.
1.1 This test method covers determination of the ash content in the analysis sample of refuse-derived fuel (RDF). The results obtained can be applied as the weight percent ash in the proximate analysis and in the ultimate analysis.
1.2 The values stated in acceptable metric units are to be regarded as standard. The values given in parentheses are for information only.
1.3 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements see Section 6.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
E180 Practice for Determining the Precision of ASTM Methods for Analysis and Testing of Industrial Chemicals
E790 Test Method for Residual Moisture in a Refuse-Derived Fuel Analysis Sample
E829 Practice for Preparing Refuse-Derived Fuel (RDF) Laboratory Samples for Analysis
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM E830-87(2004), Standard Test Method for Ash in the Analysis Sample of Refuse-Derived Fuel (Withdrawn 2004), ASTM International, West Conshohocken, PA, 1996, www.astm.orgBack to Top