ASTM E727 / E727M - 08(2020)

    Standard Test Methods for Determining Bulk Density of Granular Carriers and Granular Pesticides

    Active Standard ASTM E727 / E727M | Developed by Subcommittee: E35.22

    Book of Standards Volume: 11.08

      Format Pages Price  
    PDF 2 $46.00   ADD TO CART
    Hardcopy (shipping and handling) 2 $46.00   ADD TO CART

    Significance and Use

    3.1 These test methods were designed principally for clay, corncob, nut shell, paper-based or sand granular carriers, and granular pesticide products, but need not be limited to these materials. There may be more appropriate test methods for other types of granular carriers or pesticide products. The differences in the following test methods are slight, but they offer a choice of a recognized test procedure.

    1. Scope

    1.1 These test methods are used to determine bulk density of granular carriers and granular pesticides by measuring either free-fall bulk density (Test Method A) or loose-fill bulk density (Test Method B).

    1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements see Section 4.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    E725 Test Method for Sampling Granular Carriers and Granular Pesticides

    ICS Code

    ICS Number Code 65.100.01 (Pesticides and other agrochemicals)

    UNSPSC Code

    UNSPSC Code

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/E0727_E0727M-08R20

    Citation Format

    ASTM E727 / E727M-08(2020), Standard Test Methods for Determining Bulk Density of Granular Carriers and Granular Pesticides, ASTM International, West Conshohocken, PA, 2020,

    Back to Top