You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    ASTM E688-94(2011)

    Standard Test Methods for Waste Glass as a Raw Material for Glass Manufacturing (Withdrawn 2019)

    Withdrawn Standard: ASTM E688-94(2011) | Developed by Subcommittee: D34.03


      Format Pages Price  
    PDF 7 $60.00   ADD TO CART


    Withdrawn Rationale:

    These test methods gave the various tests for assessing the compliance of glass recovered from wastes for use as a raw material for glass manufacturing.

    Formerly under the jurisdiction of Committee D34 on Waste Management, these test methods were withdrawn in November 2019. This standard is being withdrawn without replacement due to its limited use by industry.

    1. Scope

    1.1 These test methods give the various tests for assessing the compliance of glass recovered from wastes for use as a raw material for glass manufacturing.

    1.2 The test methods combine visual examinations with both chemical and physical tests. A flow chart of the testing sequence is included in this test method (see ).

    1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For hazard statements, see , , Section , and .



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    C169 Test Methods for Chemical Analysis of Soda-Lime and Borosilicate Glass

    C566 Test Method for Total Evaporable Moisture Content of Aggregate by Drying

    C702 Practice for Reducing Samples of Aggregate to Testing Size

    C729 Test Method for Density of Glass by the Sink-Float Comparator

    D1068 Test Methods for Iron in Water

    D1193 Specification for Reagent Water

    D2576 Method of Test for Metals in Water and Waste Water by Atomic Absorption Spectrophotometry

    D4129 Test Method for Total and Organic Carbon in Water by High Temperature Oxidation and by Coulometric Detection

    E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves

    E105 Practice for Probability Sampling of Materials

    E122 Practice for Calculating Sample Size to Estimate, With Specified Precision, the Average for a Characteristic of a Lot or Process


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/E0688-94R11

    Citation Format

    ASTM E688-94(2011), Standard Test Methods for Waste Glass as a Raw Material for Glass Manufacturing (Withdrawn 2019), ASTM International, West Conshohocken, PA, 2011, www.astm.org

    Back to Top