You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    ASTM E54-80(1996)

    Standard Test Methods for Chemical Analysis of Special Brasses and Bronzes (Withdrawn 2002)

    Withdrawn Standard: ASTM E54-80(1996) | Developed by Subcommittee: E01.07


      Format Pages Price  
    PDF 8 $60.00   ADD TO CART


    1. Scope

    1.1 These test methods cover procedures for the chemical analysis of the commercial alloys known as copper-base alloy ingots for sand castings, forging rods, bars, and shapes; aluminum brass; manganese bronze; phosphor bronze; copper-silicon alloys; and similar alloys having chemical compositions within the following limits.

    Whenever possible the technique and procedures for analysis should be checked against a National Institute of Standards and Technology standard sample having a composition comparable to the material being analyzed.

    1.2 The test methods appear in the following order:

    1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For precautions to be observed in these methods, refer to Practices E50.



    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/E0054-80R96

    Citation Format

    ASTM E54-80(1996), Standard Test Methods for Chemical Analysis of Special Brasses and Bronzes (Withdrawn 2002), ASTM International, West Conshohocken, PA, 1996, www.astm.org

    Back to Top