ASTM E3108 - 18

    Standard Practice for Conformity Assessment of Protective Gloves Worn by Law Enforcement and Corrections Officers

    Active Standard ASTM E3108 | Developed by Subcommittee: E54.04

    Book of Standards Volume: 15.08


      Format Pages Price  
    PDF 5 $48.00   ADD TO CART
    Hardcopy (shipping and handling) 5 $48.00   ADD TO CART



    1. Scope

    1.1 This practice establishes the conformity assessment requirements for protective gloves worn by law enforcement and corrections officers. It was developed based on end user input regarding hazards of concern and operational requirements of officers.2

    1.2 This practice provides two options for conformity assessment: (1) supplier’s declaration of conformity (SDOC) and (2) certification.

    1.2.1 This practice is intended to be used by purchasers and suppliers in the procurement of gloves that meet Specification E3109, and the purchaser is responsible for selecting either SDOC or certification.

    Note 1: An ASTM guide is being developed to provide agencies and end users with information related to the selection, procurement, and use of protective gloves worn by law enforcement and corrections officers while on duty.

    1.2.2 The performance, testing, labeling, documentation, and reporting requirements for SDOC and for certification are specified in Specification E3109.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ISO/IEC Standards

    ISO 9000

    ISO 9001

    ISO/IEC 17000 Conformity AssessmentVocabulary and General Principles

    ISO/IEC 17011 Conformity AssessmentGeneral Requirements for Accreditation Bodies Accrediting Conformity Assessment Bodies

    ISO/IEC 17050-1

    ISO/IEC 17065


    ICS Code

    ICS Number Code 13.340.40 (Hand and arm protection)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/E3108-18

    Citation Format

    ASTM E3108-18, Standard Practice for Conformity Assessment of Protective Gloves Worn by Law Enforcement and Corrections Officers, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top