| ||Format||Pages||Price|| |
|3||$42.00||  ADD TO CART|
|Hardcopy (shipping and handling)||3||$42.00||  ADD TO CART|
1.1 This specification is intended to provide a basis for identification of strippable/removable materials used to immobilize radioactive contamination, minimize worker exposure, and facilitate subsequent decontamination or to protect uncontaminated areas against the spread of radioactive contamination.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D412 Test Methods for Vulcanized Rubber and Thermoplastic ElastomersTension
D4060 Test Method for Abrasion Resistance of Organic Coatings by the Taber Abraser
D4541 Test Method for Pull-Off Strength of Coatings Using Portable Adhesion Testers
E2731 Specification for Materials to Mitigate the Spread of Radioactive Contamination after a Radiological Dispersion Event
ICS Number Code 27.120.20 (Nuclear power plants. Safety)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM E3104-17, Standard Specification for Strippable & Removable Coatings to Mitigate Spread of Radioactive Contamination, ASTM International, West Conshohocken, PA, 2017, www.astm.orgBack to Top