If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM E2511 - 17

    Standard Guide for Detailing of EIFS-Clad Barrier and Drainage Wall Assemblies

    Active Standard ASTM E2511 | Developed by Subcommittee: E06.58

    Book of Standards Volume: 04.12

      Format Pages Price  
    PDF 3 $46.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $46.00   ADD TO CART
    Standard + Redline PDF Bundle 6 $54.00   ADD TO CART

    Significance and Use

    4.1 This guide is for use by individuals and entities involved with the design and specification of EIFS details for a specific building.

    4.2 This guide can be applied to both EIFS-clad barrier wall assembly and EIFS-clad wall with drainage.

    4.3 This guide can be applied to new and existing EIFS buildings, prefabricated versus on-site installed EIFS, and residential and commercial EIFS buildings.

    4.4 This guide is not meant to replace the types of information normally present in text format in a project’s specifications.

    4.5 This guide is not applicable to EIFS materials used in non EIFS applications, such as a topcoat for other base materials like traditional Portland cement plaster (stucco) and concrete.

    1. Scope

    1.1 This guide describes the types of project-specific construction conditions that need to be communicated by means of drawings (“details”) for the purpose of constructing Exterior Insulation and Finish System (EIFS)-clad barrier and drainage wall assemblies. EIFS manufacturers provide basic details for the installation of their materials and interface with adjacent materials. These details are generic and, in many cases, do not apply to specific project conditions.

    1.2 This guide addresses only the EIFS itself and the interface between the EIFS and the materials immediately adjacent to the EIFS; it does not address all parts of the wall assembly.

    1.3 Not all possible construction detail conditions are addressed by this guide. Identify and provide details for all construction conditions that exist on a specific building.

    1.4 This guide is intended to supplement but not supersede information from the EIFS manufacturer about how their specific product should be detailed, nor to supersede technical product acceptance reports or the code requirements of regulatory authorities.

    1.5 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

    1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    E631 Terminology of Building Constructions

    E2110 Terminology for Exterior Insulation and Finish Systems (EIFS)

    ICS Code

    ICS Number Code 91.060.10 (Walls. Partitions. Facades)

    UNSPSC Code

    UNSPSC Code 30141500(Thermal insulation)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/E2511-17

    Citation Format

    ASTM E2511-17, Standard Guide for Detailing of EIFS-Clad Barrier and Drainage Wall Assemblies, ASTM International, West Conshohocken, PA, 2017, www.astm.org

    Back to Top