| Format | Pages | Price |   |
![]() |
2 | $46.00 | ![]() |
|
![]() |
Hardcopy (shipping and handling) | 2 | $46.00 | ![]() |
Historical Version(s) - view previous versions of standard
More E06.58 Standards Related Products Standard References
Significance and Use
5.1 This specification determines levels of impact resistance under Classes PB and PI EIFS.
5.2 This test method does not purport to simulate impact encountered in service.
1. Scope
1.1 This test method covers a procedure for rapidly deforming by impact an EIFS for evaluating the effect of such deformation.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and to determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D2794 Test Method for Resistance of Organic Coatings to the Effects of Rapid Deformation (Impact)
E631 Terminology of Building Constructions
E2110 Terminology for Exterior Insulation and Finish Systems (EIFS)
ICS Code
ICS Number Code 19.020 (Test conditions and procedures in general)
UNSPSC Code
UNSPSC Code 30151900(Finishing materials and products)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/E2486_E2486M-13R18
Citation Format
ASTM E2486 / E2486M-13(2018), Standard Test Method for Impact Resistance of Class PB and PI Exterior Insulation and Finish Systems (EIFS), ASTM International, West Conshohocken, PA, 2018, www.astm.org
Back to Top