| ||Format||Pages||Price|| |
|8||$55.20||  ADD TO CART|
Formerly under the jurisdiction of Committee F06 on Resilient Floor Coverings and the direct responsibility of Subcommittee F06.40 on Practices, this guide was withdrawn in May 2008 and replaced by Practice F 710 for Preparing Concrete Floors to Receive Resilient Flooring .
1.1 This guide includes both quantitative and qualitative procedures used to determine the amount of water or water vapor present in or emitting from concrete slabs and criteria for evaluating the moisture-related acceptability of concrete slabs to receive resilient floor coverings and related adhesives.
1.2 Although carpet tiles, carpet, wood flooring ceramic tile, stone tile, coatings, films, and paints are not specifically intended to be included in the category of resilient floor coverings, the procedures included in this guide may be useful for evaluating the moisture-related acceptability of concrete slabs for such finishes.
1.3 This guide does not cover the adequacy of a concrete floor to perform its structural requirements.
1.4 This guide does not include procedures to determine the presence of non-moisture related impediments to the application of finishes.
1.5 This guide does not supersede the specific instructions or recommendations of manufacturers for their flooring finishes.
1.6 The methods are listed in this guide for reference purposes only. Refer to Practice F 710 and the flooring manufacturer for acceptable quantitative methods. For acceptance, refer to Practice F 710.
1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM E1907-06a, Standard Guide to Methods of Evaluating Moisture Conditions of Concrete Floors to Receive Resilient Floor Coverings (Withdrawn 2008), ASTM International, West Conshohocken, PA, 2006, www.astm.orgBack to Top