| Format | Pages | Price |   |
![]() |
5 | $52.00 | ![]() |
|
![]() |
Hardcopy (shipping and handling) | 5 | $52.00 | ![]() |
Historical Version(s) - view previous versions of standard
More E17.24 Standards Related Products Standard References
Abstract
This specification covers the design and construction standards, material and physical requirements, and test methods for a smooth-tread standard tire for measuring tire-pavement friction forces. When tested with appropriate methods, the tread compounds shall conform to specified values of physical properties such as tensile sheet cure, 300 % modulus, specific gravity, tensile strength, elongation, and tire tread durometer performance.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification covers the general requirements for a smooth-tread standard tire for measuring tire-pavement friction forces.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information purposes only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D297 Test Methods for Rubber ProductsChemical Analysis
D412 Test Methods for Vulcanized Rubber and Thermoplastic ElastomersTension
D1054 Test Method for Rubber Property--Resilience Using a Goodyear-Healey Rebound Pendulum
D1765 Classification System for Carbon Blacks Used in Rubber Products
D2240 Test Method for Rubber PropertyDurometer Hardness
D3182 Practice for RubberMaterials, Equipment, and Procedures for Mixing Standard Compounds and Preparing Standard Vulcanized Sheets
E867 Terminology Relating to Vehicle-Pavement Systems
ICS Code
ICS Number Code 83.160.10 (Road vehicle tyres)
UNSPSC Code
UNSPSC Code 25172500(Tires and tire tubes)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/E1844-08R20
Citation Format
ASTM E1844-08(2020), Standard Specification for a Size 10 × 4–5 Smooth-Tread Friction Test Tire, ASTM International, West Conshohocken, PA, 2020, www.astm.org
Back to Top