| Format | Pages | Price |   |
![]() |
3 | $46.00 | ![]() |
|
![]() |
Hardcopy (shipping and handling) | 3 | $46.00 | ![]() |
![]() |
Standard + Redline PDF Bundle ![]() |
6 | $54.00 | ![]() |
Historical Version(s) - view previous versions of standard
More E01.05 Standards Related Products Standard References
Significance and Use
5.1 This practice for sampling of cast blister copper is intended primarily to test such materials for compliance with compositional specifications. It is assumed that all who use these methods shall be trained samplers capable of performing common sampling procedures skillfully and safely.
5.2 The selection of correct test pieces and the preparation of a representative sample from such test pieces are necessary prerequisites to every analysis. The analytical results will be of little value unless the sample represents the average composition of the material from which it was prepared.
1. Scope
1.1 This practice describes a procedure for the sampling and sample preparation of cast blister copper for the determination of chemical composition.
1.2 This practice is intended to cover the general principles of sampling applicable to cast blister copper forms.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E135 Terminology Relating to Analytical Chemistry for Metals, Ores, and Related Materials
ICS Code
ICS Number Code 71.040.50 (Physicochemical methods of analysis)
UNSPSC Code
UNSPSC Code 12141711(Copper Cu)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/E1833-07AR13E01
Citation Format
ASTM E1833-07a(2013)e1, Standard Practice for Sampling of Blister Copper in Cast Form for Determination of Chemical Composition, ASTM International, West Conshohocken, PA, 2013, www.astm.org
Back to Top