ASTM D95 - 13(2018)

    Método de prueba estándar para contenido de agua de productos derivados del petróleo y materiales bituminosos por destilación

    Active Standard ASTM D95 Developed by Subcommittee: D02.02

    Book of Standards Volume: 05.01


      Format Pages Price  
    PDF 9 $62.00   ADD TO CART

    Historical Version(s) - view previous versions of standard

    Translated Standard(s): English

    ASTM License Agreement

    More D02.02 Standards Related Products


    Significance and Use

    5.1 A knowledge of the water content of petroleum products is important in the refining, purchase, sale, and transfer of products.

    5.2 The amount of water as determined by this test method (to the nearest 0.05 % or 0.1 % by volume, depending on the trap size used) may be used to correct the volume involved in the custody transfer of petroleum products and bituminous materials.

    5.3 The allowable amount of water may be specified in contracts.

    1. Alcance

    1.1 This test method covers the determination of water in the range from 0 % to 25 % by volume in petroleum products, tars, and other bituminous materials by the distillation method.

    Note 1: Volatile water-soluble material, if present, may be measured as water.

    1.2 The specific products considered during the development of this test method are listed in Table  1. For bituminous emulsions refer to Test Method D244. For crude oils, refer to Test Method D4006 (API MPMS Chapter 10.2).

    Note 2: With some types of oil, satisfactory results may be obtained from Test Method D1796 (API MPMS Chapter 10.6).

    1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 6.

    1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Documentos Citados