| Format | Pages | Price |   |
![]() |
5 | $52.00 | ![]() |
|
![]() |
Hardcopy (shipping and handling) | 5 | $52.00 | ![]() |
1. Scope
1.1 This specification covers hot-applied asphalt aggregate-filled mastics for repairing distresses in asphalt pavements and hydraulic concrete pavements. These distresses include, but are not limited to: depressions, wide cracks not suitable for crack sealing, pot holes, corner breaks and longitudinal joint distresses, and other repairs smaller than those requiring remove and replace procedures.
1.2 The values stated in SI units are to be regarded as standard. No other units are included in this standard.
1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D1985 Practice for Preparing Concrete Blocks for Testing Sealants, for Joints and Cracks
D2794 Test Method for Resistance of Organic Coatings to the Effects of Rapid Deformation (Impact)
D3666 Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials
D4989/D4989M Test Method for Apparent Viscosity (Flow) of Roofing Bitumens Using the Parallel Plate Plastometer
E171/E171M Practice for Conditioning and Testing Flexible Barrier Packaging
ICS Code
ICS Number Code 93.080.20 (Road construction materials)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/D8260-20
Citation Format
ASTM D8260-20, Standard Specification for Hot-Applied Asphalt Aggregate-Filled Mastic, ASTM International, West Conshohocken, PA, 2020, www.astm.org
Back to Top