If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM D8241 / D8241M - 19

    Standard Tables of Body Measurements for Young Men Type, Size Range 32 – 48

    Active Standard ASTM D8241 / D8241M | Developed by Subcommittee: D13.55

    Book of Standards Volume: 07.02

      Format Pages Price  
    PDF 8 $52.00   ADD TO CART
    Hardcopy (shipping and handling) 8 $52.00   ADD TO CART

    Significance and Use

    4.1 The use of the body measurement information in Table 1 and Table 2 will assist manufacturers in developing patterns and garments that are consistent with the current anthropometric characteristics of the population of interest. This practice should, in turn, reduce or minimize consumer confusion and dissatisfaction related to apparel sizing (also refer to ISO 3635 Size Designation Procedures).

    4.2 Three-dimensional avatars depicting each of the young men sizes were created by Alvanon, Inc. and included in this standard to assist manufacturers in visualizing the posture, shape, and proportions generated by the measurements charts in Table 1 and Table 2. (See Figs. 1-6.)

    FIG. 1 Form Front View 32-38

    Form Front View 32-38Form Front View 32-38

    FIG. 2 Form Front View 39-48

    Form Front View 39-48Form Front View 39-48

    FIG. 3 Form Side View 32-38

    Form Side View 32-38Form Side View 32-38

    FIG. 4 Form Side View 39-48

    Form Side View 39-48Form Side View 39-48

    FIG. 5 Form Back View 32-38

    Form Back View 32-38Form Back View 32-38

    FIG. 6 Form Back View 39-48

    Form Back View 39-48Form Back View 39-48

    1. Scope

    1.1 These tables list body measurements of young men figure type sizes 32-48. Although these are body measurements, they can be used as a baseline in designing apparel for young men in this size range when considering such factors as fabric type, ease for body movement, styling, and fit.

    1.2 These tables list body measurements for the complete range of young men sizing.

    1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D123 Terminology Relating to Textiles

    D5219 Terminology Relating to Body Dimensions for Apparel Sizing

    ISO Standard

    ISO 3635:1981

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D8241_D8241M-19

    Citation Format

    ASTM D8241 / D8241M-19, Standard Tables of Body Measurements for Young Men Type, Size Range 32 – 48, ASTM International, West Conshohocken, PA, 2019, www.astm.org

    Back to Top