ASTM D8099 / D8099M - 17

    Standard Specification for Asphalt Emulsion Pavement Sealer (Mineral Colloid or Chemically Stabilized Type)

    Active Standard ASTM D8099 / D8099M | Developed by Subcommittee: D08.09

    Book of Standards Volume: 04.04


      Format Pages Price  
    PDF 2 $42.00   ADD TO CART
    Hardcopy (shipping and handling) 2 $42.00   ADD TO CART



    1. Scope

    1.1 This specification covers water based asphalt emulsion (mineral colloid or chemically stabilized type) pavement sealer suitable for use as a weather-protective coating over bituminous pavements, such as roadways, parking areas, and driveways.

    Note 1: Application shall be made in accordance with a forthcoming ASTM standard on the application of asphalt emulsion pavement sealer.

    1.2 The values stated in SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    C136/C136M Test Method for Sieve Analysis of Fine and Coarse Aggregates

    C142/C142M Test Method for Clay Lumps and Friable Particles in Aggregates

    D95 Test Method for Water in Petroleum Products and Bituminous Materials by Distillation

    D140/D140M Practice for Sampling Asphalt Materials

    D2939 Test Methods for Emulsified Bitumens Used as Protective Coatings


    ICS Code

    ICS Number Code 93.080.20 (Road construction materials)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D8099_D8099M-17

    Citation Format

    ASTM D8099 / D8099M-17, Standard Specification for Asphalt Emulsion Pavement Sealer (Mineral Colloid or Chemically Stabilized Type), ASTM International, West Conshohocken, PA, 2017, www.astm.org

    Back to Top