ASTM D8082 - 18

    Standard Specification for Elemental Impurity Limits in Erosion Control Products used for Land Application

    Active Standard ASTM D8082 | Developed by Subcommittee: D18.25

    Book of Standards Volume: 04.09


      Format Pages Price  
    PDF 2 $44.00   ADD TO CART
    Hardcopy (shipping and handling) 2 $44.00   ADD TO CART



    1. Scope

    1.1 This standard provides a specification for elemental impurity limits in erosion control products used for land application. Erosion control products may include but are not limited to: hydraulically-applied erosion control products, rolled erosion control products, sediment retention devices, gabions and mattresses, and articulated concrete block revetments.

    1.2 Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

    1.3 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026, unless superseded by this specification.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D653 Terminology Relating to Soil, Rock, and Contained Fluids

    D3740 Practice for Minimum Requirements for Agencies Engaged in Testing and/or Inspection of Soil and Rock as Used in Engineering Design and Construction

    D3987 Practice for Shake Extraction of Solid Waste with Water

    D6026 Practice for Using Significant Digits in Geotechnical Data


    ICS Code

    ICS Number Code 13.080.01 (Soil quality and pedology in general)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D8082-18

    Citation Format

    ASTM D8082-18, Standard Specification for Elemental Impurity Limits in Erosion Control Products used for Land Application, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top