If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM D8057 - 17

    Standard Specification for Inlet Filters with a Rigid Frame

    Active Standard ASTM D8057 | Developed by Subcommittee: D35.03

    Book of Standards Volume: 04.13

      Format Pages Price  
    PDF 3 $48.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $48.00   ADD TO CART

    1. Scope

    1.1 This specification covers geosynthetic storm sewer inlet filters used in highway drainage, roadway, residential, commercial, and industrial applications. The inlet filter is comprised of a rigid frame and a removable geosynthetic sediment bag. The sediment bag hangs suspended from the rigid frame and includes a bypass that shall allow water flow into the drainage structure if the bag is completely filled with sediment. Water flow through the bypass shall equal or exceed the design flow of the inlet required at a specified drainage location.

    1.2 The requirements of this specification are intended to provide an inlet filter system to collect sediment, trash, leaves, and other storm water contaminants from surface storm water runoff at drainage inlet locations during temporary site construction.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D4439 Terminology for Geosynthetics

    D5141 Test Method for Determining Filtering Efficiency and Flow Rate of the Filtration Component of a Sediment Retention Device

    D7351 Test Method for Determination of Sediment Retention Device Effectiveness in Sheet Flow Applications

    AASHTO Standards

    AASHTO M288

    ICS Code

    ICS Number Code 59.080.70 (Geotextiles)

    UNSPSC Code

    UNSPSC Code 70171802(Storm water drainage)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D8057-17

    Citation Format

    ASTM D8057-17, Standard Specification for Inlet Filters with a Rigid Frame, ASTM International, West Conshohocken, PA, 2017, www.astm.org

    Back to Top