| Format | Pages | Price |   |
![]() |
3 | $46.00 | ![]() |
|
![]() |
Hardcopy (shipping and handling) | 3 | $46.00 | ![]() |
![]() |
Standard + Redline PDF Bundle ![]() |
6 | $54.00 | ![]() |
Historical Version(s) - view previous versions of standard
More D02.G0.02 Standards Related Products Standard References
Significance and Use
5.1 It is known that contamination by water can affect the structural stability of some greases in service. The test procedure specified in this method is widely used to determine the wet structural stability of greases in service. Many grease specifications require this procedure as a wet structural stability test. No accurate correlation is established between the test results and wet structural stability of grease in actual service.
1. Scope
1.1 This test method covers a procedure for determining the roll stability of lubricating grease in the presence of water (wet roll stability) by using a roll stability test apparatus.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D217 Test Methods for Cone Penetration of Lubricating Grease
D1193 Specification for Reagent Water
D1403 Test Methods for Cone Penetration of Lubricating Grease Using One-Quarter and One-Half Scale Cone Equipment
D1831 Test Method for Roll Stability of Lubricating Grease
D4057 Practice for Manual Sampling of Petroleum and Petroleum Products
ICS Code
ICS Number Code 75.100 (Lubricants, industrial oils and related products)
UNSPSC Code
UNSPSC Code 15121900(Greases)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/D8022-20
Citation Format
ASTM D8022-20, Standard Test Method for Roll Stability of Lubricating Grease in Presence of Water (Wet Roll Stability Test), ASTM International, West Conshohocken, PA, 2020, www.astm.org
Back to Top