ASTM D8015 - 15(2019)

    Standard Test Method for Dimensional Changes of Elastomer and Rubber Materials Due to Exposure to Gaseous Hydrocarbon Environments

    Active Standard ASTM D8015 | Developed by Subcommittee: D11.15

    Book of Standards Volume: 09.02

      Format Pages Price  
    PDF 4 $44.00   ADD TO CART
    Hardcopy (shipping and handling) 4 $44.00   ADD TO CART

    Significance and Use

    5.1 The information provided by this test method is useful for manufacturing quality control, technical service, and research purposes; and is required by various material specifications.

    5.2 This method is suitable for all elastomer or rubber materials.

    1. Scope

    1.1 This standard gives the testing procedure to determine the change in dimensions of specimens of rubber or elastomeric materials, or both, resulting from exposure to gaseous hydrocarbon environments. The size of the specimens is such to facilitate preparation from as molded component configurations such as gaskets and seals. Where agreed to by both parties molded specimens may be used. Dimensional measurements are made prior to and after conditioning in a formulated test gas.

    1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1418 Practice for Rubber and Rubber LaticesNomenclature

    D1566 Terminology Relating to Rubber

    ICS Code

    ICS Number Code 83.140.01 (Rubber and plastic products in general)

    UNSPSC Code

    UNSPSC Code 13100000(Rubber and elastomers)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D8015-15R19

    Citation Format

    ASTM D8015-15(2019), Standard Test Method for Dimensional Changes of Elastomer and Rubber Materials Due to Exposure to Gaseous Hydrocarbon Environments, ASTM International, West Conshohocken, PA, 2019,

    Back to Top