ASTM D8000 - 15

    Standard Practice for Flow Conditioning of Natural Gas and Liquids

    Active Standard ASTM D8000 | Developed by Subcommittee: D03.12

    Book of Standards Volume: 05.06


      Format Pages Price  
    PDF 16 $56.00   ADD TO CART
    Hardcopy (shipping and handling) 16 $56.00   ADD TO CART



    Significance and Use

    4.1 Flow conditioners are used for the conditioning of the turbulent flow profile of gases or liquids to reduce the ADD (velocity profile distortion) DEL (turbulence), swirl, or irregularities caused by the installation effects of piping elbows, length of pipe, valves, tees, and other such equipment or piping configurations that will affect the reading of flow measurement meters thus inducing measurement errors as a result of the flow profile of the gas or liquid not having a fully developed flow profile at the measurement point.4

    1. Scope

    1.1 This practice covers flow conditioners that produce a fully developed flow profile for liquid and gas phase fluid flow for circular duct sizes 1- to 60-in. (25.4- to 1525-mm) diameter and Reynolds Number (Re) ranges from transition (100) to 100 000 000. These flow conditioners can be used for any type of flow meter or development of a fully developed flow profile for other uses.

    1.2 The central single-hole configuration that is derived using fundamental screen theory is referenced as the flow conditioner described herein.

    1.3 Piping lengths upstream and downstream of a flow conditioner are considered a critical component of a flow conditioner and constitute the complete flow conditioner system.

    1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D4150 Terminology Relating to Gaseous Fuels

    AGA Standard

    AGA Report No. 8


    ICS Code

    ICS Number Code 17.120.10 (Flow in closed conduits)

    UNSPSC Code

    UNSPSC Code


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D8000-15

    Citation Format

    ASTM D8000-15, Standard Practice for Flow Conditioning of Natural Gas and Liquids, ASTM International, West Conshohocken, PA, 2015, www.astm.org

    Back to Top