| Format | Pages | Price |   |
![]() |
21 | $75.00 | ![]() |
|
![]() |
Hardcopy (shipping and handling) | 21 | $75.00 | ![]() |
Historical Version(s) - view previous versions of standard
More D02.96.06 Standards Related Products Standard References
1. Scope
1.1 This practice is intended to cover the extraction, analysis, and information management pertaining to visible wear debris collected from oil system filters or debris retention screens. Further, it is intended that this practice be a practical reference for those involved in FDA.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Other Standards
TTCP-AER-TP3-TR01-2010 Guide for Filter Debris Analysis Published by the Technical Co-operation Program (TTCP), July 2010.ASTM Standards
D4175 Terminology Relating to Petroleum Products, Liquid Fuels, and Lubricants
D7684 Guide for Microscopic Characterization of Particles from In-Service Lubricants
D7685 Practice for In-Line, Full Flow, Inductive Sensor for Ferromagnetic and Non-ferromagnetic Wear Debris Determination and Diagnostics for Aero-Derivative and Aircraft Gas Turbine Engine Bearings
D7690 Practice for Microscopic Characterization of Particles from In-Service Lubricants by Analytical Ferrography
D7720 Guide for Statistically Evaluating Measurand Alarm Limits when Using Oil Analysis to Monitor Equipment and Oil for Fitness and Contamination
F316 Test Methods for Pore Size Characteristics of Membrane Filters by Bubble Point and Mean Flow Pore Test
G40 Terminology Relating to Wear and Erosion
ICS Code
ICS Number Code 23.100.60 (Filters, seals and contamination of fluids)
UNSPSC Code
UNSPSC Code 40161504(Oil filters)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/D7898-14R20
Citation Format
ASTM D7898-14(2020), Standard Practice for Lubrication and Hydraulic Filter Debris Analysis (FDA) for Condition Monitoring of Machinery, ASTM International, West Conshohocken, PA, 2020, www.astm.org
Back to Top