If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM D7711 - 11(2015)

    Standard Guide for Description of Polymer Pellet Defects

    Active Standard ASTM D7711 | Developed by Subcommittee: D20.92

    Book of Standards Volume: 08.03

      Format Pages Price  
    PDF 2 $46.00   ADD TO CART
    Hardcopy (shipping and handling) 2 $46.00   ADD TO CART

    Significance and Use

    4.1 This guide is intended to provide terminology for both suppliers and users of polymer pellets to ensure mutual understanding in discussions concerning pellet defects. It is not an absolute standard but is to be referred to when issues with the quality and/or description of the polymeric materials arise.

    4.2 The guide is categorized according to the best fit for the term and its description for ease of finding certain description types.

    4.3 Some terms within this guide do not apply to all resin types. It is the user’s responsibility to determine if the term and its subsequent definition are applicable to the material in question.

    4.4 Other terminology relating to polymers that are not included in this document can be found in additional standards such as Terminology D883.

    1. Scope

    1.1 This guide is a compilation of terms used to describe defects of polymeric pellets. Terms that are generally understood or defined adequately in Terminology D883 or in other readily available sources are not included.

    1.2 Not every term is applicable to every type of pellet. Terms which apply to transparent pellets, for example, do not always apply to translucent or opaque pellets.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    Note 1: There is no known ISO equivalent to this guide.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D883 Terminology Relating to Plastics

    ICS Code

    ICS Number Code 83.080.01 (Plastics in general)

    UNSPSC Code

    UNSPSC Code

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D7711-11R15

    Citation Format

    ASTM D7711-11(2015), Standard Guide for Description of Polymer Pellet Defects, ASTM International, West Conshohocken, PA, 2015, www.astm.org

    Back to Top