ASTM D7710 - 14

    Standard Test Method for Determination of Volume and Density of Rigid and Irregularly Shaped Molded Cellular Materials

    Active Standard ASTM D7710 | Developed by Subcommittee: D20.22

    Book of Standards Volume: 08.03


      Format Pages Price  
    PDF 3 $42.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $42.00   ADD TO CART



    Significance and Use

    4.1 The test procedure provides a standard method of obtaining data for research and development, quality control, acceptance and rejection under specifications and for special purposes.

    4.2 The data obtained by this test method is applicable to the material under the conditions of this particular test and are not necessarily the same as obtained under other environments in use.

    1. Scope

    1.1 This test method is used to determine the volume and density of irregularly shaped molded products.

    1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.

    Note 1: There is no known ISO equivalent to this standard.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method


    ICS Code

    ICS Number Code 83.100 (Cellular materials)

    UNSPSC Code

    UNSPSC Code 13111300(Foams)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D7710-14

    Citation Format

    ASTM D7710-14, Standard Test Method for Determination of Volume and Density of Rigid and Irregularly Shaped Molded Cellular Materials, ASTM International, West Conshohocken, PA, 2014, www.astm.org

    Back to Top