If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM D7513 - 17

    Standard Test Method for Capacity of Mixed Bed Ion Exchange Cartridges

    Active Standard ASTM D7513 | Developed by Subcommittee: D19.08

    Book of Standards Volume: 11.02

      Format Pages Price  
    PDF 4 $48.00   ADD TO CART
    Hardcopy (shipping and handling) 4 $48.00   ADD TO CART
    Standard + Redline PDF Bundle 8 $56.00   ADD TO CART

    Significance and Use

    5.1 This test method can be used to evaluate unused mixed bed ion exchange cartridges for conformance to specifications.

    5.2 This test method provides for the calculation of capacity in terms of the volume of water treated to a conductivity end point.

    5.3 The test method as written assumes that the ion exchange resins in the cartridge are either partially or fully converted to the H+ or OH form. Regeneration of the resins is not part of this method.

    5.4 This test method provides for the calculation of capacity on a cartridge basis.

    5.5 This test method may be used to test different size mixed bed resin cartridges. The flow rate of test water and the frequency of sampling are varied to compensate for the approximate volume of resin in the test cartridge.

    1. Scope

    1.1 This test method covers the determination of the performance of mixed bed ion exchange resin cartridges in the active form when used for deionization. The test can be used to determine the initial capacity of unused cartridges or the remaining capacity of used cartridges. In this case performance is defined as ion exchange capacity (or throughput) to two defined endpoints. The method does not measure organics and does not attempt to determine the ultimate water quality attainable by the cartridge.

    1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1125 Test Methods for Electrical Conductivity and Resistivity of Water

    D1129 Terminology Relating to Water

    D1193 Specification for Reagent Water

    D3375 Test Method for Column Capacity of Particulate Mixed Bed IonExchange Materials

    D5391 Test Method for Electrical Conductivity and Resistivity of a Flowing High Purity Water Sample

    ICS Code

    ICS Number Code 71.100.40 (Surface active agents)

    UNSPSC Code

    UNSPSC Code

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D7513-17

    Citation Format

    ASTM D7513-17, Standard Test Method for Capacity of Mixed Bed Ion Exchange Cartridges, ASTM International, West Conshohocken, PA, 2017, www.astm.org

    Back to Top