If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM D7379 / D7379M - 08(2021)

    Standard Test Methods for Strength of Modified Bitumen Sheet Material Laps Using Cold Process Adhesive

    Active Standard ASTM D7379 / D7379M | Developed by Subcommittee: D08.04

    Book of Standards Volume: 04.04


      Format Pages Price  
    PDF 4 $46.00   ADD TO CART
    Hardcopy (shipping and handling) 4 $46.00   ADD TO CART



    Significance and Use

    3.1 These tests are useful in sampling and testing combinations of modified bitumen sheet materials used with cold-applied adhesives.

    1. Scope

    1.1 These test methods cover the procedure for sampling and testing the strength of laps formed with adhesive used with polymer-modified bituminous sheet materials.

    1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D140/D140M Practice for Sampling Asphalt Materials

    D146/D146M Test Methods for Sampling and Testing Bitumen-Saturated Felts and Woven Fabrics for Roofing and Waterproofing

    D5147/D5147M Test Methods for Sampling and Testing Modified Bituminous Sheet Material


    ICS Code

    ICS Number Code 91.100.50 (Binders. Sealing materials)

    UNSPSC Code

    UNSPSC Code 30121504(Bitumen)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D7379_D7379M-08R21

    Citation Format

    ASTM D7379 / D7379M-08(2021), Standard Test Methods for Strength of Modified Bitumen Sheet Material Laps Using Cold Process Adhesive, ASTM International, West Conshohocken, PA, 2021, www.astm.org

    Back to Top