If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM D7239 - 13(2018)

    Standard Specification for Hybrid Geosynthetic Paving Mat for Highway Applications

    Active Standard ASTM D7239 | Developed by Subcommittee: D35.06

    Book of Standards Volume: 04.13

      Format Pages Price  
    PDF 4 $48.00   ADD TO CART
    Hardcopy (shipping and handling) 4 $48.00   ADD TO CART

    1. Scope

    1.1 This is a material specification covering hybrid geosynthetic paving mats typically used for, but not limited to, use in joint and localized (spot) pavement repairs; and paving mats intended for curb-to-curb coverage to provide a moisture barrier for the pavement structure and retard reflective cracking in bituminous overlays. They are typically nonwoven in construction. This is a material purchasing specification, and design review of use is recommended.

    1.2 This is not a construction or design specification. This specification is based on hybrid geosynthetic paving mat survivability from installation stresses.

    1.3 For purposes of determining conformance to this specification, values for length or area shall be rounded to the nearest 0.1 m or 0.1 m2, respectively. Values for mass shall be rounded to the nearest gram, and for force to the nearest Newton, and volume to the nearest 0.01 L, in accordance with the rounding method in Practice E29.

    1.4 The text of this standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables) shall not be considered as requirements of the standard.

    1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

    1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D123 Terminology Relating to Textiles

    D276 Test Methods for Identification of Fibers in Textiles

    D4354 Practice for Sampling of Geosynthetics and Rolled Erosion Control Products (RECPs) for Testing

    D4439 Terminology for Geosynthetics

    D4759 Practice for Determining the Specification Conformance of Geosynthetics

    D5035 Test Method for Breaking Force and Elongation of Textile Fabrics (Strip Method)

    D5261 Test Method for Measuring Mass per Unit Area of Geotextiles

    D6140 Test Method to Determine Asphalt Retention of Paving Fabrics Used in Asphalt Paving for Full-Width Applications

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

    ICS Code

    ICS Number Code 59.080.70 (Geotextiles)

    UNSPSC Code

    UNSPSC Code

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D7239-13R18

    Citation Format

    ASTM D7239-13(2018), Standard Specification for Hybrid Geosynthetic Paving Mat for Highway Applications, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top