| Format | Pages | Price |   |
![]() |
2 | $46.00 | ![]() |
|
![]() |
Hardcopy (shipping and handling) | 2 | $46.00 | ![]() |
Historical Version(s) - view previous versions of standard
More D35.10 Standards Related Products Standard References
Significance and Use
4.1 This test method evaluates grab tensile properties of reinforced geomembranes for the purposes of quality control, quality assurance and research. In order to evaluate the full contribution of the reinforcement, testing is performed parallel to the directions of reinforcement. This test method is an index test and is not intended for design purposes.
1. Scope
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D76/D76M Specification for Tensile Testing Machines for Textiles
D4354 Practice for Sampling of Geosynthetics and Rolled Erosion Control Products(RECPs) for Testing
D4439 Terminology for Geosynthetics
ICS Code
ICS Number Code 59.080.70 (Geotextiles)
UNSPSC Code
UNSPSC Code
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/D7004_D7004M-03R13E01
Citation Format
ASTM D7004 / D7004M-03(2013)e1, Standard Test Method for Grab Tensile Properties of Reinforced Geomembranes, ASTM International, West Conshohocken, PA, 2013, www.astm.org
Back to Top