ASTM D6935 - 17

    Standard Test Method for Determining Cement Mixing of Emulsified Asphalt

    Active Standard ASTM D6935 | Developed by Subcommittee: D04.42

    Book of Standards Volume: 04.03


      Format Pages Price  
    PDF 2 $41.00   ADD TO CART
    Hardcopy (shipping and handling) 2 $41.00   ADD TO CART
    Standard + Redline PDF Bundle 4 $49.20   ADD TO CART


    Significance and Use

    3.1 The result of this test method indicates the ability of a slow-setting emulsified asphalt to mix with a finely divided, high-surface-area material (high early strength, Type III, portland cement) without breaking the emulsified asphalt.

    1. Scope

    1.1 This test method is intended to be a mixing test used to identify or classify a slow-setting, SS or CSS, type of emulsified asphalt.

    1.2 The values stated in SI units are to be regarded as standard. No other units of measure are included in this standard.

    1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements for the standard.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    C115 Test Method for Fineness of Portland Cement by the Turbidimeter

    C150 Specification for Portland Cement

    D6934 Test Method for Residue by Evaporation of Emulsified Asphalt

    D6997 Test Method for Distillation of Emulsified Asphalt

    E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves


    ICS Code

    ICS Number Code 93.080.20 (Road construction materials)

    UNSPSC Code

    UNSPSC Code 30121601(Asphalt)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D6935-17

    Citation Format

    ASTM D6935-17, Standard Test Method for Determining Cement Mixing of Emulsified Asphalt, ASTM International, West Conshohocken, PA, 2017, www.astm.org

    Back to Top