ASTM D6930 - 19

    Standard Test Method for Settlement and Storage Stability of Emulsified Asphalts

    Active Standard ASTM D6930 | Developed by Subcommittee: D04.42

    Book of Standards Volume: 04.03


      Format Pages Price  
    PDF 3 $42.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $42.00   ADD TO CART
    Standard + Redline PDF Bundle 6 $50.00   ADD TO CART



    Significance and Use

    3.1 This test method is useful for determining, in a comparatively short time, the storage stability or settlement of an emulsified asphalt. It is a measure of the permanence of the dispersion as related to time, but it is not to be construed to have significance as a measure of other stability aspects involved in use.

    Note 1: The quality of the results produced by this standard are dependent on the competence of the personnel performing the procedure and the capability, calibration, and maintenance of the equipment used. Agencies that meet the criteria of Specification D3666 are generally considered capable of competent and objective testing, sampling, inspection, etc. Users of this standard are cautioned that compliance with Specification D3666 alone does not completely ensure reliable results. Reliable results depend on many factors; following the suggestions of Specification D3666 or some similar acceptance guideline provides a means of evaluating and controlling some of those factors.

    1. Scope

    1.1 This test method covers the ability of an emulsified asphalt to remain as a uniform dispersion during storage. It is applicable to emulsified asphalts composed principally of a semisolid or liquid asphaltic base, water, and an emulsifying agent.

    1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

    1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D3666 Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials

    D6934 Test Method for Residue by Evaporation of Emulsified Asphalt


    ICS Code

    ICS Number Code 93.080.20 (Road construction materials)

    UNSPSC Code

    UNSPSC Code 30121601(Asphalt)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D6930-19

    Citation Format

    ASTM D6930-19, Standard Test Method for Settlement and Storage Stability of Emulsified Asphalts, ASTM International, West Conshohocken, PA, 2019, www.astm.org

    Back to Top