You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    ASTM D6847-02

    Standard Test Method for Quantitative Extraction and Recovery of Asphalt Binder from Asphalt Mixtures (Withdrawn 2010)

    Withdrawn Standard: ASTM D6847-02 | Developed by Subcommittee: D04.25

      Format Pages Price  
    PDF 9 $55.20   ADD TO CART

    Withdrawn Rationale:

    Formerly under the jurisdiction of Committee D04 on Road and Paving Materials, this Test Method was withdrawn in 2010 with no replacement because very few labs have the equipment to run the procedure (and those that do tend to reference the AASHTO procedure T319). There are too few labs to run the required interlaboratory study.

    1. Scope

    1.1 This test method covers a procedure for the extraction and recovery of asphalt binder from asphalt mixtures-both HMA (hot mix asphalt) and RAP (reclaimed/recycled asphalt pavement)—having a minimal effect on the physical properties of the asphalt binder recovered. It is primarily intended for use when the physical properties of the recovered asphalt are to be determined. It can also be used to determine the quantity of asphalt binder in the HMA or RAP. Recovered aggregate may be used for sieve analysis. This may also be accomplished through Test Methods D 2172.

    1.2 The values stated in SI units are regarded as the standard. Values in parentheses are for informational use.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    Note 1—It is suggested that agency and personnel performing this test meet the requirements of Specification D 3666.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D75 Practice for Sampling Aggregates

    D979 Practice for Sampling Bituminous Paving Mixtures

    D1461 Test Method for Moisture or Volatile Distillates in Bituminous Paving Mixtures

    D2172 Test Methods for Quantitative Extraction of Bitumen From Bituminous Paving Mixtures

    D2939 Test Methods for Emulsified Bitumens Used as Protective Coatings

    D3666 Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials

    D4753 Specification for Evaluating, Selecting, and Specifying Balances and Scales for Use in Testing Soil, Rock, and Related Construction Materials

    D5361 Practice for Sampling Compacted Bituminous Mixtures for Laboratory Testing

    D5444 Test Method for Mechanical Size Analysis of Extracted Aggregate

    E11 Specification for Wire Cloth and Sieves for Testing Purposes

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D6847-02

    Citation Format

    ASTM D6847-02, Standard Test Method for Quantitative Extraction and Recovery of Asphalt Binder from Asphalt Mixtures (Withdrawn 2010), ASTM International, West Conshohocken, PA, 2002,

    Back to Top