ASTM D6787 / D6787M - 02(2017)

    Standard Specification for Repositionable Note Pad

    Active Standard ASTM D6787 / D6787M | Developed by Subcommittee: D10.14

    Book of Standards Volume: 15.10


      Format Pages Price  
    PDF 4 $41.00   ADD TO CART
    Hardcopy (shipping and handling) 4 $41.00   ADD TO CART


    Abstract

    This specification covers pads of repositionable, colored, note paper. Each sheet has a strip of pressure-sensitive adhesive on the back side. A hand-operated steel roller shall be used in the manufacture of the pads and a cylindrical mandrel shall be used for flagging test of the pads. A minimum average of determined sheets of paper shall be assembled in the form of a pad. No individual pad shall contain less than a certain number of sheets. The pad of paper and a backing sheet shall be securely fastened together by means of the repositionable, pressure-sensitive adhesive coating. The paper to be used in the manufacture of the pad shall be determined by its basis weight and thickness. In order to determine the sheets' overall performance, the following properties shall be tested: writing quality, sheet removal, multiple sheet lift, fiber pull, initial flagging, and repositionable flagging. The sheets of pad paper shall be clean and free from dirt, foreign matter, holes, tears, wrinkles, and other defects which might affect appearance or serviceability. The sheets shall be uniform with respect to color and formation. Pads shall be square cut with smooth, clean edges.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers pads of repositionable, colored, note paper. Each sheet has a strip of pressure-sensitive adhesive on the back side.

    1.2 The values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system must be used independently, without combining values in any way.

    1.3 The following safety hazards caveat pertains only to Section 14, Performance Requirements. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D3715/D3715M Practice for Quality Assurance of Pressure-Sensitive Tapes

    D3951 Practice for Commercial Packaging

    D4332 Practice for Conditioning Containers, Packages, or Packaging Components for Testing


    ICS Code

    ICS Number Code 85.080.10 (Office paper)

    UNSPSC Code

    UNSPSC Code


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D6787_D6787M-02R17

    Citation Format

    ASTM D6787 / D6787M-02(2017), Standard Specification for Repositionable Note Pad, ASTM International, West Conshohocken, PA, 2017, www.astm.org

    Back to Top